Editing John Deere Blitz Black paint

==Summary== John Deere Blitz Black is enamel paint manufactured by Valspar Paint for John Deere, for the purpose of painting farm equipment. It's popular among hotrodders because it's an inexpensive and durable finish for vehicles, that provides the look of a primered "rat" or "traditional" hot rod (described as: "flat", "suede", "satin", or "semi-gloss"). It's weatherproof, and blocks UV light, where a bare primer would soak up water and oils. Although John Deer Blitz Black paint can be applied with typical paint equipment, John Deere recommends using their own primer and reducer. The paint and the primer are typically $25 dollars for a gallon, and the reducer is about $15 for a quart. They are also sold in quarts and spray cans, so you can experiment with various primered or bare metal surfaces. ==How to apply== #If the existing paint doesn't have peeling paint or large amounts of rust, then no primer is necessary. Sand with extra fine grit sand paper, wipe with a clean cloth, and then apply JDBB paint. #If a primer is needed, JDBB primer is recommended (it's available in spray cans, quarts, and gallons). #JDBB reducer is needed, at a mix ratio of 8 parts JDBB paint:1 part John Deere thinner. #For faster-drying and harder paint, John Deere hardener can be used. It's available in pints. When using the hardener, the mix ration is 8 parts JDBB paint:1 part John Deere thinner to 1 part John Deere hardener. #Spray one light tack coat, and wait no longer than 15 minutes to shoot the full wet coat. #Wait no longer than 3 hours to apply a second coat. However, one coat with the 8:1:1 paint-thinner-hardener ratio should be adequate. #A gallon will easily cover a small car. ==Part numbers== *Blitz Black paint: TY-25669 (formerly TY-6416) *Primer: TY6457 *Reducer: PT158 *Hardener: REN3001 ==Cautions== John Deere Blitz Black paint will not work on engine blocks, headers, pipes, or any other high-heat areas. And, it will not retard rust growth. ==Notes== It dries fast. Be wary of striping. To help striping, some people recommend using regular enamel reducer instead of the John Deere reducer. Also, hold the gun at a 90 degree angle to the surface, and keep a 50% overlap. ==Where to get it== [http://www.eberhardequipment.com/ Eberhard Equipment] ==Can I use a clearcoat with John Deere Blitz Black paint? How can I get a glossy look?== Although not intended for glossy black finishes, a clearcoat can be applied over JDBB paint if a flattening agent is used. Or, try wet sanding or buffing. ==Photographs of JDBB paint jobs== ==Unsettled issues== Is this the same paint that's featured on this page: http://www.valspar.com/val/resident/valspar_imp.jsp ==Alternatives to John Deere Blitz Black paint== *Asphalt (#MQ2818) with Egg Shell clear coat (#P-FKT600)and , produced by [http://www.color-rite.com Color-Rite]. == References == *[http://www.valspar.com Valspar.com] *[http://www.hotrodders.com/forum/john-deere-blitz-black-31993.html Hotrodders Bulletin Board discussion]

| Editing help (opens in new window)