Editing Valve train points to check

'''Things that need to be checked and verified to be correct:'''

*Springs for installed height
*Coil bind
*Retainer to seal/ valve guide boss at full lift
*Retainer to rocker
*Trunnion to stud boss
*Piston to valve (also both before and after TDC on overlap)
*Push rod to guide slot in head (if used)
*Rocker to valve tip (by adjusting guide plates if used)
*Rocker slot to stud (if using stamped/cast rockers w/pivot balls)
*Proper geometry (push rod length)
*Rocker/polyloc to valve cover or baffle
*Camshaft endplay
*Distributor shaft and gear endplay
*Distributor gear to cam gear mesh pattern
*Proper hydraulic lifter preload

[[Category:Engine]]

[[Category:Good articles]]