Media blasting

Jump to: navigation, search
(Where to get media)
Line 61: Line 61:
 
Cautions about this.
 
Cautions about this.
  
* Prolonged sand blasting of thin sheet metal causes frictional heat that may cause the metal to ding, warp, or pit. Be aware of this if you especially are going to be doing a long, flat, unsupported body panel. The best way to avoid this on long spans is to spread out the blast from the gun so that not one area recieves the brunt of the abrasive blast for a long period of time. It also gives it time to cool.
+
* Prolonged sand blasting of thin sheet metal causes frictional heat that may cause the metal to ding, warp, or pit. Be aware of this if you especially are going to be doing a long, flat, unsupported body panel. The best way to avoid this on long spans is to spread out the blast from the gun so that not one area receives the brunt of the abrasive blast for a long period of time. It also gives it time to cool.
  
 
==Recycling media==
 
==Recycling media==
 
*Don't recycle media that has been used to blast undercoating -- it contaminates the media.
 
*Don't recycle media that has been used to blast undercoating -- it contaminates the media.
  
*Most media recycles very nicely, with the larger particles breaking down into smaller, sharper ones. Exentually, it will be broken down so far that it cannot diffuse into smaller particles, and the media will have to be replaced.
+
*Most media recycles very nicely, with the larger particles breaking down into smaller, sharper ones. Eventually, it will be broken down so far that it cannot diffuse into smaller particles, and the media will have to be replaced.
  
 
==Safety==
 
==Safety==
Line 75: Line 75:
 
*Long pants and sleeves
 
*Long pants and sleeves
  
*Fully enclosed shoes (remembr to put your socks over you pants!)
+
*Fully enclosed shoes (remember to put your socks over you pants!)
  
*A facemask with safety goggles worn underneath
+
*A face mask with safety goggles worn underneath
  
*Leather Gloves (media dosnt feel the gretest on your hands when coming out at 100PSI+)
+
*Leather Gloves (media doesn't feel the greatest on your hands when coming out at 100PSI+)
  
 
*Respirator (NOT a cheap paper one, the cartridge-type is the one you want)
 
*Respirator (NOT a cheap paper one, the cartridge-type is the one you want)

Revision as of 09:14, 4 February 2009

Personal tools
Namespaces
Variants
Actions
Navigation
Categories
Toolbox