Removing stuck fasteners
(→Miscellaneous tips) |
|||
| Line 146: | Line 146: | ||
==Miscellaneous tips== | ==Miscellaneous tips== | ||
*Weld a piece of metal to the top of the bolt, to use as leverage when loosening. | *Weld a piece of metal to the top of the bolt, to use as leverage when loosening. | ||
| − | *If the slot of a round-headed screw is stripped, file two flat edges in it. Then, it can be turned with an adjustable wrench. Or, use a hacksaw to file a new slot at a right angle to the existing one. | + | *If the slot of a round-headed screw is stripped, file two flat edges in it. Then, it can be turned with an adjustable wrench. Or, use a hacksaw to file a new slot at a right angle to the existing one. Depending on the size of the fastener, using a Dremel tool or a die-grinder with a fiber wheel, carefully grind a large, deep slot in the head of the fastener, and before it cools, use a large screwdriver to remove the fastener. |
*Six-point sockets will grip better on hex nuts and bolts than 12-point sockets. | *Six-point sockets will grip better on hex nuts and bolts than 12-point sockets. | ||
*Drill and tap the bolt to run another, smaller bolt down the center. A bit about half the diameter of the headless, stuck bolt is usually sufficient. Use a jam nut on the small bolt and lots of penetrating oil. | *Drill and tap the bolt to run another, smaller bolt down the center. A bit about half the diameter of the headless, stuck bolt is usually sufficient. Use a jam nut on the small bolt and lots of penetrating oil. | ||
Your Privacy Choices