TH350 rebuild tech
| Line 22: | Line 22: | ||
| − | Install new seals on the low piston, these are square cut seals, not lip seals. Then push it into the rear of the case evenly by hand, aligning it properly so it will seat (there is a "tang"). Look at the park pawl notch to help index it. | + | Install new seals on the low piston, these are square cut seals, not lip seals. |
| + | |||
| + | [[File:TH350lowpiston.jpg]] | ||
| + | |||
| + | Then push it into the rear of the case evenly by hand, aligning it properly so it will seat (there is a "tang"). Look at the park pawl notch to help index it. | ||
| + | |||
| + | |||
| + | [[file:TH350caselowpiston.jpg]] | ||
Then install the return spring and retainer using the tool pictured. | Then install the return spring and retainer using the tool pictured. | ||
| + | [[file:TH350lowspringtool.jpg]] | ||
| + | [[file:TH350caselowtool.jpg]] | ||
Next you install the output shaft | Next you install the output shaft | ||
Your Privacy Choices