Head gasket

Jump to: navigation, search

@@ Line 30: / Line 30: @@
 ====MLS head gaskets====
-Sealant use may be required when retrofitting MLS(multi-layers) head gaskets to engines which were not originally produced with MLS head gaskets, or when using MLS head gaskets on engines that have not been properly prepared. For proper coolant and oil sealing, MLS head gaskets require surface finishes of 30 RA (Roughness Average) or finer, this is because the elastomeric coating on the sealing surfaces of MLS head gaskets is approximately .001" thick which is too thin to seal leak paths in the peaks and valleys of rougher (RA30+) finishes.
+Sealant use may be required when retrofitting MLS(multi-layer steel) head gaskets to engines which were not originally produced with MLS head gaskets, or when using MLS head gaskets on engines that have not been properly prepared. For proper coolant and oil sealing, MLS head gaskets require surface finishes of 30 RA (Roughness Average) or finer, this is because the elastomeric coating on the sealing surfaces of MLS head gaskets is approximately .001" thick which is too thin to seal leak paths in the peaks and valleys of rougher (RA30+) finishes.
 ====Steel shim head gasket====

Revision as of 17:28, 16 October 2011