TH350 rebuild tech
(Add text; clean up) |
(→Intermediate clutch clearance: add text, pdf link; minor clean up) |
||
| Line 300: | Line 300: | ||
==Intermediate clutch clearance== | ==Intermediate clutch clearance== | ||
| − | After the pump is set into place to test end play clearance, you can also check the clutch clearance on the intermediate clutch pack. Clearance of 0.050" to 0.070" will work well. There are thicker steel plates available if need to tighten up the clutch pack clearance. Also, a scraped low-reverse friction can be used under the intermediate friction if need be. A scraped friction will measure about 0.032". | + | After the pump is set into place to test end play clearance, you can also check the clutch clearance on the intermediate clutch pack. Clearance of 0.050" to 0.070" will work well. There are thicker intermediate steel plates available if need to tighten up the clutch pack clearance. Intermediate steels [[media:Usgmth35004.pdf|'''are available''']] (see page 40) in 0.068", 0.078" and 0.089" thicknesses, some manufacturers may use slightly different thicknesses than these. |
| + | |||
| + | Also, a scraped low-reverse friction can be used under the intermediate friction if need be. A scraped friction will measure about 0.032". | ||
[[File:T-350_intermed_clearance_ck.jpg|thumb|300px|left|TH350 intermediate clutch pack clearance can be checked through this hole]] <br style="clear:both"/> | [[File:T-350_intermed_clearance_ck.jpg|thumb|300px|left|TH350 intermediate clutch pack clearance can be checked through this hole]] <br style="clear:both"/> | ||
Your Privacy Choices