TH350 rebuild tech
(→Rear planetary unit install) |
m (Reverted edits by 71.102.68.65 (talk) to last revision by Cobalt327) |
||
| Line 111: | Line 111: | ||
Once it is pushed into place, install the snap ring with the ends on each side of the spring or case-saver. | Once it is pushed into place, install the snap ring with the ends on each side of the spring or case-saver. | ||
| − | Now is the time to air check the low clutches. You do so by applying pressurized air to the passage at the rear pan area of the worm casting in the case. | + | Now is the time to air check the low clutches. You do so by applying pressurized air to the passage at the rear pan area of the worm casting in the case. |
Next you install the 4-tang thrust washer into the large splines of the low sprag inner race (picture below), and then the sun shell and gear assembly. | Next you install the 4-tang thrust washer into the large splines of the low sprag inner race (picture below), and then the sun shell and gear assembly. | ||
Your Privacy Choices