How to cut steel braided cable
From Crankshaft Coalition Wiki
| Line 5: | Line 5: | ||
After cutting, give the inside a shot of WD40 and place an AN fitting in a padded vice jaw, put a hold-down clamp on the hose (but don't tighten it yet) and push the hose on with a slight twisting motion. Remove the tape and push into place or put hold-down clamp in to place and crimp it. | After cutting, give the inside a shot of WD40 and place an AN fitting in a padded vice jaw, put a hold-down clamp on the hose (but don't tighten it yet) and push the hose on with a slight twisting motion. Remove the tape and push into place or put hold-down clamp in to place and crimp it. | ||
| − | Another easy way of doing it, if you don't have a cut-off wheel handy is with a chisel. Just wrap the cable with tape like described above to keep the threads from fraying. Set it on a solid piece of stock, or concrete works sometimes, put the chisel in the middle of your taped section and hit it with a hammer. It generally cuts very easily. Hope this helps. | + | Another easy way of doing it, if you don't have a cut-off wheel handy is with a cold chisel. Just wrap the cable with tape like described above to keep the threads from fraying. Set it on a solid piece of stock, or concrete works sometimes, put the cold chisel in the middle of your taped section and hit it with a hammer. It generally cuts very easily. Hope this helps. |
| + | |||
| + | I have found another way of cutting cable of less than 1/4 inch cleanly. Wrap the cable with electrical tape. Then take a block of hard wood (6 inch long 2 x 2 is ideal) and stand it up in a vice. Drill a hole a bit larger than the cable about 1 inch from the end. Turn the block 90 degrees and using the hacksaw cut down through the wood, past the hole. Feed the cable through the hole and cut. | ||
A word of caution - when using the cut off wheel, make sure you are wearing eye protection as little pieces of stainless steel will go flying. As far as bloody finger tip - sorry, you take your chances with braided cable, but good mechanics' gloves will help some. | A word of caution - when using the cut off wheel, make sure you are wearing eye protection as little pieces of stainless steel will go flying. As far as bloody finger tip - sorry, you take your chances with braided cable, but good mechanics' gloves will help some. | ||
Your Privacy Choices