Vortec L31 cylinder head
(→Technical specs) |
(→Valve springs, retainers and locks) |
||
| Line 215: | Line 215: | ||
[[File:Vortec beehive.jpg|thumb|left|300px|Straight wound spring, Left; Beehive spring, right]] | [[File:Vortec beehive.jpg|thumb|left|300px|Straight wound spring, Left; Beehive spring, right]] | ||
<br style="clear:both"/> | <br style="clear:both"/> | ||
| − | The stock Vortec valve springs are single wound without a damper and are 1.250" diameter. The damping is done by the spring ID (. | + | The stock Vortec valve springs are single wound without a damper and are 1.250" diameter. The damping is done by the spring ID (.896") being a close fit to the guide boss OD (0.852"); this damps the spring without the added cost of an inner flat wound damper seen on the Gen 1 SBC throughout its production. If you have aftermarket springs designed for the earlier heads, you must remove the inner damper because the damper ID will be too small to fit over the guide boss without it being cut smaller. If the boss is cut smaller, a damper should be used. |
| − | The stock springs are not suited for high performance use or for lifts above about 0. | + | The stock springs are not suited for high performance use or for lifts above about 0.460" using stock retainers. There are several replacements for the stock springs, among the best is the beehive spring and retainer combination from Comp Cams, originally designed for the LS engine series: |
*'''[http://www.compcams.com/WhatsNew/NewsDetails.aspx?ListHistoryID=164462240 p/n 26915]'''- 105 pounds at 1.8" installed height; open pressure 293 lbs. at 1.2"; coil bind at 1.100"; spring rate 313 lbs./in.; bottom OD 1.290" | *'''[http://www.compcams.com/WhatsNew/NewsDetails.aspx?ListHistoryID=164462240 p/n 26915]'''- 105 pounds at 1.8" installed height; open pressure 293 lbs. at 1.2"; coil bind at 1.100"; spring rate 313 lbs./in.; bottom OD 1.290" | ||
*'''[http://www.compcams.com/WhatsNew/NewsDetails.aspx?ListHistoryID=1166393320 p/n 26918]'''- 125 pounds at 1.8" installed height; open pressure 367 pounds at 1.15"; coil bind 1.100"; spring rate 372 lbs./in.; '''bottom OD 1.310"''' <br> | *'''[http://www.compcams.com/WhatsNew/NewsDetails.aspx?ListHistoryID=1166393320 p/n 26918]'''- 125 pounds at 1.8" installed height; open pressure 367 pounds at 1.15"; coil bind 1.100"; spring rate 372 lbs./in.; '''bottom OD 1.310"''' <br> | ||
Your Privacy Choices