Removing stuck fasteners
From Crankshaft Coalition Wiki
(→Some recommended penetrating fluids: - added PlusGas) |
(→References) |
||
| Line 102: | Line 102: | ||
**[http://www.crcindustries.com/auto/content/prod_detail.aspx?PN=05330&S=Y Ultra Screwloose] | **[http://www.crcindustries.com/auto/content/prod_detail.aspx?PN=05330&S=Y Ultra Screwloose] | ||
*Diesel fuel | *Diesel fuel | ||
| + | *[https: //www.lawsonproducts .com/Drummond/Open-and-Shut-Nut-and-Bolt-Loosener-and-Rust-Penetrant/DA6152.lp Drummond Open and Shut]<ref>https: //www.hotrodders .com/forum/best-penetrating-lubricant-147009.html#post1033340</ref> | ||
| + | *[https: //www.lawsonproducts .com/Drummond/Open-and-Shut-NutBolt-LoosenerRust-Penetrant/DA7671.lp Drummond Open and Shut]<ref>https: //www.hotrodders .com/forum/best-penetrating-lubricant-147009.html#post1033340</ref> | ||
*[http://www.lubecorp.com/products/excel_440_super_lubricant.html Excel 440 Super Lubricant] | *[http://www.lubecorp.com/products/excel_440_super_lubricant.html Excel 440 Super Lubricant] | ||
*[http://www.bilthamber.com/ferrosol.html Ferrosol] | *[http://www.bilthamber.com/ferrosol.html Ferrosol] | ||
| Line 214: | Line 216: | ||
*Whatever system you use, once you have a hold of the fastener, try rocking it forward and reverse a little at a time. If you can get it to move, it is more likely to come out. An older mechanic said always try to tighten a little before you loosen. Remember, if it moves, you are half way home. | *Whatever system you use, once you have a hold of the fastener, try rocking it forward and reverse a little at a time. If you can get it to move, it is more likely to come out. An older mechanic said always try to tighten a little before you loosen. Remember, if it moves, you are half way home. | ||
*Use the largest cobalt drill bit (that just covers the ID of the nut) to drill through the nut- parallel to the bolt- then used a chisel to turn/peel the nut off of the bolt. | *Use the largest cobalt drill bit (that just covers the ID of the nut) to drill through the nut- parallel to the bolt- then used a chisel to turn/peel the nut off of the bolt. | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
Your Privacy Choices