Stripping paint
From Crankshaft Coalition Wiki
(→Crud removal air tools) |
|||
| Line 1: | Line 1: | ||
| − | + | ||
==Inspecting the panel before stripping== | ==Inspecting the panel before stripping== | ||
If the paint is still shiny, before getting rid of it, use it to your advantage to find waves and dents in the body. | If the paint is still shiny, before getting rid of it, use it to your advantage to find waves and dents in the body. | ||
| Line 57: | Line 57: | ||
====Homemade scraping tool==== | ====Homemade scraping tool==== | ||
| − | Start with a stiff putty knife or drywall tool. Round the corners, then re-sharpen on a belt sander, then on a knife sharpening stone. Hold the knife with both hands, at a 90-degree angle to the surface. Start to scrape, and adjust the angle until you get the best results. | + | Start with a stiff putty knife or drywall tool. Round the corners, then re-sharpen on a belt sander. Only sharpen one side, not both, then on a knife sharpening stone. Hold the knife with both hands, at a 90-degree angle to the surface. Start to scrape, and adjust the angle until you get the best results. As it wears, you can resharpen the blade with a DA sander: 80-180-320. that'll get it razor sharp again. |
====Media blasting==== | ====Media blasting==== | ||
| Line 110: | Line 110: | ||
===Other methods=== | ===Other methods=== | ||
If the paint is brittle when you chip it off, it could be acrylic urethane. If so, try using a heat gun. You might be able to peel the paint off after applying a little heat. | If the paint is brittle when you chip it off, it could be acrylic urethane. If so, try using a heat gun. You might be able to peel the paint off after applying a little heat. | ||
| + | |||
| + | |||
| + | Peeling paint can be removed with a high pressure pressure washer., be careful, you can damage plastic parts. Northern tool makes a wet blaster that you hook up to the pressure washer to wet sandblast, no dust but it makes a mess. | ||
==Methods of NOT stripping paint== | ==Methods of NOT stripping paint== | ||
Using an angle grinder is not a recommended way of getting rid of paint. The grit is too coarse and will damage the metal and would require some type of body filler: extra work you really don't want or need to get into. | Using an angle grinder is not a recommended way of getting rid of paint. The grit is too coarse and will damage the metal and would require some type of body filler: extra work you really don't want or need to get into. | ||
| + | |||
| + | ==Supplies== | ||
| + | *[http://www.tcpglobal.com/autobodydepot/paintremove.aspx Paint stripping tools and products from TCPGlobal.com] | ||
[[Category:Body and exterior]] | [[Category:Body and exterior]] | ||
Your Privacy Choices