Long term storage preparation

From Crankshaft Coalition Wiki
Jump to: navigation, search
m (Coolant)
 
Line 1: Line 1:
{{youcanedit}}
+
 
 
==Overview==
 
==Overview==
 
If storing a vehicle for the winter or longer, a few precautionary steps can make a difference.
 
If storing a vehicle for the winter or longer, a few precautionary steps can make a difference.
Line 12: Line 12:
 
*When running a vehicle during storage time, be sure to bring it up to full operating temperature, and keep it there for a while. This will prevent internal condensation in the engine and oil.
 
*When running a vehicle during storage time, be sure to bring it up to full operating temperature, and keep it there for a while. This will prevent internal condensation in the engine and oil.
 
*For long term storage, one of the most important things that you can do is to remove the spark plugs and squirt some light oil into the cylinders then rotate the engine a couple turns, then screw the plugs back in finger tight. This will keep your pistons and rings from seizing. When you then take it out of storage you can remove the plugs and spin the engine over with the starter to remove most of the oil.  Then re-install the plugs and your ready to start your engine. Or you could use a product known as [http://www.amsoil.com/storefront/fog.aspx fogging oil]. It is in a spray can and you spray it down the intake while running at a high idle then you finally allow the engine to choke down and die. This will coat everything in the upper cylinders with a light lubricant.
 
*For long term storage, one of the most important things that you can do is to remove the spark plugs and squirt some light oil into the cylinders then rotate the engine a couple turns, then screw the plugs back in finger tight. This will keep your pistons and rings from seizing. When you then take it out of storage you can remove the plugs and spin the engine over with the starter to remove most of the oil.  Then re-install the plugs and your ready to start your engine. Or you could use a product known as [http://www.amsoil.com/storefront/fog.aspx fogging oil]. It is in a spray can and you spray it down the intake while running at a high idle then you finally allow the engine to choke down and die. This will coat everything in the upper cylinders with a light lubricant.
 
+
*You can place a vehicle on four jack stands that are sitting in oil drain pans, pour a small amount of used oil in the pans so that the bottom is completely covered. This will prevent rodents from entering your vehicle because they won't cross the oil.
 
==Tips==
 
==Tips==
 
It's obviously always better to store a vehicle in a climate-controlled environment. This isn't always possible, so if there's going to be a lot of heat or sunshine on the vehicle, protect the dash with a sun screen and a UV protectant. Cover the upholstery w/sheets to keep the sun off it. A breathable fabric [http://www.carcoverusa.com/NOAH-Car-Cover.html car cover] can provide a good amount of protection both indoors and outdoors if tied down properly. Avoid cheap covers- they can damage the finish.  
 
It's obviously always better to store a vehicle in a climate-controlled environment. This isn't always possible, so if there's going to be a lot of heat or sunshine on the vehicle, protect the dash with a sun screen and a UV protectant. Cover the upholstery w/sheets to keep the sun off it. A breathable fabric [http://www.carcoverusa.com/NOAH-Car-Cover.html car cover] can provide a good amount of protection both indoors and outdoors if tied down properly. Avoid cheap covers- they can damage the finish.  
Line 21: Line 21:
 
Check anti-freeze for proper freeze protection. Tools are available from cheap to expensive for testing the effectiveness of coolant for freeze and boil over protection. An easy to use and accurate method is to use test strips. They are simply dipped into a sample of the coolant and the color change will indicate the coolant condition.
 
Check anti-freeze for proper freeze protection. Tools are available from cheap to expensive for testing the effectiveness of coolant for freeze and boil over protection. An easy to use and accurate method is to use test strips. They are simply dipped into a sample of the coolant and the color change will indicate the coolant condition.
  
<gallery widths=150px caption="Coolant testing equipment/supplies">
+
<gallery widths=250px caption="Coolant testing equipment/supplies">
 
File:Coolant tester.jpg|Simple, inexpensive bulb tester
 
File:Coolant tester.jpg|Simple, inexpensive bulb tester
 
File:WIX-coolant strips.jpg|WIX coolant test strips
 
File:WIX-coolant strips.jpg|WIX coolant test strips
Line 34: Line 34:
 
==Suppliers==
 
==Suppliers==
 
*[http://www.meguiars.com/en/automotive/products/ Meguiars automotive products]
 
*[http://www.meguiars.com/en/automotive/products/ Meguiars automotive products]
*[http://www.grainger.com/Grainger/EXTECH-Portable-Coolant-Refractometer-3MY57 Extech Portable Refractometer] at Grainger.
+
*[http://www.grainger.com/Grainger/EXTECH-Portable-Coolant-Refractometer-3MY57 Extech Portable Refractometer] at Grainger
*[http://www.summitracing.com/search/Brand/Wix-Filters/Product-Line/WIX-Filters-Coolant-Test-Strips/?autoview=SKU WIX test strips] at Summit Racing.
+
*[http://www.summitracing.com/search/Brand/Wix-Filters/Product-Line/WIX-Filters-Coolant-Test-Strips/?autoview=SKU WIX test strips] at Summit Racing
*[http://www.carcoverusa.com/NOAH-Car-Cover.html Noah car covers.
+
*[http://www.carcoverusa.com/NOAH-Car-Cover.html Noah car covers]
 
   
 
   
 
[[Category:Garage and shop]]
 
[[Category:Garage and shop]]
 
[[Category:General hotrodding]]
 
[[Category:General hotrodding]]

Latest revision as of 12:35, 25 November 2023

Personal tools
Namespaces
Variants
Actions
Navigation
Categories
Toolbox