How to rebuild an engine
From Crankshaft Coalition Wiki
(→Selecting tools) |
|||
| Line 4: | Line 4: | ||
You will need a basic set of hand tools, such as a good variety of boxed end wrenches, ratchet and socket set, screwdriver set, and a gasket scraper. This basic set of tools will get you through the majority of the disassembly steps. | You will need a basic set of hand tools, such as a good variety of boxed end wrenches, ratchet and socket set, screwdriver set, and a gasket scraper. This basic set of tools will get you through the majority of the disassembly steps. | ||
| − | You will need a few special tools when it comes time to build or reassemble the engine. A good torque wrench | + | You will need a few special tools when it comes time to build or reassemble the engine. A good torque wrench and a cam bearing installing tool (or have the machine shop install the cam bearings). Also, you may need a ridge reamer, a ring groove cleaner (a piece of a broken ring can be carefully used for this), a ring expander, a ring trimmer, a ring compressor, and a good cylinder hone. If cylinder head work is going to be done, a spring compressor will be needed. |
Depending on how in-depth and involved you want to get with your rebuild(s) and how many engines you think you are going to rebuild, you may want to acquire some additional measuring equipment. Items such as a set of outside micrometers, an inside micrometer, vernier, dial or digital calipers and maybe a dial bore gauge can let you know precisely what your sizes are. A "snap gauge" set can be used for spring installed height, bore diameter, etc. Think of these tools as indispensable if you are planning to blueprint your engine or if this is going to become a routine thing. You will also need a decent engine stand. It will make your build easier to support the engine, keeping it from the ground, and also helps in tearing the engine down and keeping the engine clean at assembly time. An engine hoist is also a good addition if you plan on pulling and installing many engines. | Depending on how in-depth and involved you want to get with your rebuild(s) and how many engines you think you are going to rebuild, you may want to acquire some additional measuring equipment. Items such as a set of outside micrometers, an inside micrometer, vernier, dial or digital calipers and maybe a dial bore gauge can let you know precisely what your sizes are. A "snap gauge" set can be used for spring installed height, bore diameter, etc. Think of these tools as indispensable if you are planning to blueprint your engine or if this is going to become a routine thing. You will also need a decent engine stand. It will make your build easier to support the engine, keeping it from the ground, and also helps in tearing the engine down and keeping the engine clean at assembly time. An engine hoist is also a good addition if you plan on pulling and installing many engines. | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
===Purchasing tools=== | ===Purchasing tools=== | ||
| Line 299: | Line 286: | ||
*[http://www.crankshaftcoalition.com/wiki/Category:Adjust_valves Adjust valves] | *[http://www.crankshaftcoalition.com/wiki/Category:Adjust_valves Adjust valves] | ||
*[[Engine inspection]] | *[[Engine inspection]] | ||
| − | |||
| − | |||
| − | |||
| − | |||
Your Privacy Choices