Horns
From Crankshaft Coalition Wiki
(New page: '''How to troubleshoot a horn?''' ==References== *http://www.hotrodders.com/forum/horn-question-163695.html Category:Electrical Category:Undeveloped articles) |
|||
Line 1: | Line 1: | ||
− | + | ==Choosing a horn== | |
+ | Details on how to choose a horn for a hot rod or street rod. | ||
− | == | + | ==Aftermarket suppliers== |
− | + | ||
− | + | ==Recommended salvage horns== | |
− | [[ | + | *Late model Chevrolet truck. |
+ | * '86-'92 Caddy horns have a big car sound | ||
+ | * '66-'69 Lincoln | ||
+ | * '90-2002 Safari van have two small flat type horns (have to pull the grille though) | ||
+ | |||
+ | ==Troubleshooting horns== | ||
+ | Most automobile horns are electric. They generally use full battery current and require a few basic things: | ||
+ | *a ground | ||
+ | *full battery current | ||
+ | *a relay | ||
+ | *a momentary switch to turn it on and off | ||
+ | *wiring/terminals/connectors to complete the circuit | ||
+ | |||
+ | ==Preliminary checks== | ||
+ | [[File:Circuittestlight.jpg|thumb|100px|Common circuit test light]] | ||
+ | A couple things can be easily checked before diving into the wiring and the other parts of the circuit. | ||
+ | |||
+ | First, see that the fuse or circuit breaker is good. This can be done with a test light to see if current is passing through the fuse in the fuse block, or by using an multimeter (VOM) set to 20 VDC to check to see that there is voltage into and out of the fuse or cb. If the fuse/cb is removed from the fuse box it can be tested for continuity using the ohm setting of the VOM. | ||
+ | |||
+ | Newer vehicles often have the relay located under the dash adjacent to the fuse box or in that general area. These relays will click loud enough when the horn is pressed that they can be heard. This will help to locate it as well as give an indication that current is at least reaching the relay- although the current may not be passing through it. | ||
+ | |||
+ | ==References= |