Block deck height

From Crankshaft Coalition Wiki

Jump to: navigation, search

@@ Line 24: / Line 24: @@
 *[http://www.wallaceracing.com/dynamic-cr.php Wallace Racing DCR calculator]
 *[http://www.rbracing-rsr.com/comprAdvHD.htm RSR DCR calculator]
-{{Note1}} Some dynamic compression ratio calculators (like KBs) ask for an additional 15 degrees of duration be added to the IVC @ 0.050" lift point figure. This works OK on older, slower ramped cam lobes, but the faster lobe profiles may need to have 25 degrees or more added to be accurate.<br>
+{{Note1}} Some dynamic compression ratio calculators (like KBs) ask for an additional 15 degrees of duration be added to the IVC @ 0.050" lift point figure. <br>
 {{Note1}}If the intake valve closing (IVC) point isn't known, it can be calculated:
@@ Line 37: / Line 37: @@
 [[Category:Undeveloped articles]]
 [[Category:Undeveloped Engine articles]]
-Note 1 above is stated backwards. Newer fast ramped cams are usually good with 15* added.Older slow ramp cams will need more added

Latest revision as of 13:18, 2 September 2016