Finding vacuum leaks
From Crankshaft Coalition Wiki
m (→Causes) |
(→"Untraceable" vacuum leak) |
||
| Line 14: | Line 14: | ||
**AT modulator | **AT modulator | ||
**Brake booster quite commonly un or misdiagnosed | **Brake booster quite commonly un or misdiagnosed | ||
| − | [little harder brake pedal | + | [little harder brake pedal remove booster vac line plug & idle will improve] |
**Vacuum advance canister | **Vacuum advance canister | ||
**Carb choke pull-off | **Carb choke pull-off | ||
| Line 77: | Line 77: | ||
Occasionally on engines that use the intake manifold to seal the lifter valley, you may experience a vacuum leak from the lifter valley area into the intake ports. This may be due to a bad gasket seal or because the intake manifold-to-cylinder head interface was not machined parallel (usually done to correct for [[milling cylinder heads]] and/or block). | Occasionally on engines that use the intake manifold to seal the lifter valley, you may experience a vacuum leak from the lifter valley area into the intake ports. This may be due to a bad gasket seal or because the intake manifold-to-cylinder head interface was not machined parallel (usually done to correct for [[milling cylinder heads]] and/or block). | ||
| − | No amount of propane or carburetor cleaner will find such leaks. The best way to insure there's no such problem is to use quality intake gaskets installed correctly, and to double check any machining before final assembly of the engine. | + | No amount of propane or carburetor cleaner will find such leaks. The best way to insure there's no such problem is to use quality intake gaskets installed correctly, and to double check any machining before final assembly of the engine. |
| + | These can be found by removing pcv and plugging pcv hole and attaching vac gauge to pcv inlet, then seeing if crankcase develops vacuum! GM 3.1, 3.4, and 3,8 engines have these problems often. | ||
==Resources== | ==Resources== | ||
Your Privacy Choices