Troubleshooting electrical problems
From Crankshaft Coalition Wiki
m (→Resources) |
|||
| Line 3: | Line 3: | ||
==Cleaning terminals== | ==Cleaning terminals== | ||
| − | Start at the battery. Regardless of how the connections look, remove the cables. Remove the | + | Start at the battery. Regardless of how the connections look, remove the cables. Remove the negative cable first, then the positive cable. Removing them in the opposite order will cause arcing if there is any charge in the battery. Use a battery terminal wire brush tool to clean the battery terminals and the cable terminals. Remove all old oxidized contaminants. Be aware that lead is likely present, so wear gloves if you are concerned about lead migrating through your skin. |
To prevent future corrosion, a light coating of non-conducting grease such as Dow Corning DC4 should be applied. While a professional might not recommend this, I had Japanese mechanics put regular bearing grease on my car battery terminals when I was overseas and it never presented a problem. It seemed to prevent acid build up and corrosion. | To prevent future corrosion, a light coating of non-conducting grease such as Dow Corning DC4 should be applied. While a professional might not recommend this, I had Japanese mechanics put regular bearing grease on my car battery terminals when I was overseas and it never presented a problem. It seemed to prevent acid build up and corrosion. | ||
| Line 65: | Line 65: | ||
[[Category:Electrical]] | [[Category:Electrical]] | ||
[[Category:Troubleshooting]] | [[Category:Troubleshooting]] | ||
| − | |||
| − | |||
| − | |||
Your Privacy Choices