Talk:Removing stuck fasteners
From Crankshaft Coalition Wiki
(oralnot) |
m (Add templates) |
||
| Line 1: | Line 1: | ||
| − | + | {{Note1}}{{Sign2}} | |
| − | Welding a nut onto a broken bolt, flush with the casting or whatever tends to make for a poor weld. As a blacksmith for 55 years, I always found it much better to weld on a clean uncoated flat washer. Use higher welding 'heat' to expand and break down rust, etc. Then try a large pliers or smaller pipe wrench. Or, weld a larger nut onto the washer, which will allow better and stronger welding. Always let cool to room temp BEFORE | + | Welding a nut onto a broken bolt, flush with the casting or whatever tends to make for a poor weld. As a blacksmith for 55 years, I always found it much better to weld on a clean uncoated flat washer. Use higher welding 'heat' to expand and break down rust, etc. Then try a large pliers or smaller pipe wrench. Or, weld a larger nut onto the washer, which will allow better and stronger welding. Always let cool to room temp BEFORE attempting any removal of bolt. |
Your Privacy Choices