Finding vacuum leaks
m (Undo revision 12174 by 116.0.113.19 (Talk)) |
|||
| Line 1: | Line 1: | ||
| − | + | {{youcanedit}} | |
| − | + | There are several methods for locating vacuum leaks. Occasionally, you may experience a vacuum leak into the intake ports from the crankcase of the motor due to the intake manifold / cylinder head interface not being machined parallel. No amount of propane or carburetor cleaner will find such a leak. The best way is to insure the elimination of such a problem while building the motor. See the wiki article: [[Manifold/Head vacuum leak, internal]]. | |
| − | + | ||
| − | [ | + | =Propane method= |
| − | + | ||
| − | + | #Get a soldering propane tank and valve attachment. | |
| − | + | #Unscrew the end of it so you have a threaded pipe without the nozzle. | |
| − | + | #Attach a 2 foot piece of hose to the end. | |
| − | + | #Start the engine and let it warm up a bit. | |
| − | + | #Turn on the propane and run the hose all around the vacuum lines and the bottom of the carb. | |
| − | + | #If the engine smooths out or revs up a bit, you have found your leak. | |
| − | + | ||
| − | + | Hold bottle UPRIGHT during testing as liquid propane may run out of an inverted bottle. | |
| − | + | ||
| − | + | PLEASE do this in a well ventilated area due to propane gas and exhaust fumes!! | |
| − | + | ||
| − | + | =Carburetor cleaner method= | |
| − | + | #With the car running, using a can of carburetor cleaner spray down the hoses and vacuum connections. | |
| − | [ | + | #Notice a change in the running of the engine and you might have found your leak. |
| − | + | ||
| + | [[Category:Engine]] | ||
Your Privacy Choices