TH400 rebuild tech
(→Jakeshoe rebuild tech:) |
m (center support section mod) |
||
| Line 83: | Line 83: | ||
It is best to adjust rear endplay on the tight side. On a Th400 (unless it has straight cut planetary gears) the planets will try to thrust load against the case bearing and the center support. | It is best to adjust rear endplay on the tight side. On a Th400 (unless it has straight cut planetary gears) the planets will try to thrust load against the case bearing and the center support. | ||
| + | ===Rear planetary setup=== | ||
I disassemble the rear output shaft from the output ring gear and clean and inspect the planets. Refer to manual for checking procedures and specs. It is shown here re-assembled with the reaction carrier and sun gear ready to be re-assembled. | I disassemble the rear output shaft from the output ring gear and clean and inspect the planets. Refer to manual for checking procedures and specs. It is shown here re-assembled with the reaction carrier and sun gear ready to be re-assembled. | ||
| Line 94: | Line 95: | ||
[[file:Reaction_tube.jpg]] | [[file:Reaction_tube.jpg]] | ||
| + | ===Center support assembly=== | ||
It is best to have the center support already ready. | It is best to have the center support already ready. | ||
Your Privacy Choices