TH350 rebuild tech
(→Out put shaft install) |
|||
| Line 86: | Line 86: | ||
[[file:TH350inputplanetthrust.jpg]] | [[file:TH350inputplanetthrust.jpg]] | ||
| − | Install the input planet next, | + | Install the input planet next, pictured below with thrust washer installed. |
| + | [[file:T-350_front_planet.jpg]] | ||
| − | Now, | + | Now, To prevent excessive end play, a pump thrust washer can be installed on top of the input planet, then the regular thrust washer. Then install the small outside snap ring to hold it all in place. |
| − | To prevent excessive | + | |
Check the output shaft for proper rotation, there will be some drag, especially in one direction. | Check the output shaft for proper rotation, there will be some drag, especially in one direction. | ||
Check for excessive output end play. If end play is excessive, it can be tightened up by dis-assembling and shimming up the output ring gear bearing from the case. | Check for excessive output end play. If end play is excessive, it can be tightened up by dis-assembling and shimming up the output ring gear bearing from the case. | ||
Your Privacy Choices