TH350 rebuild tech
(→Out put shaft install) |
m (→Out put shaft install) |
||
| Line 76: | Line 76: | ||
Now is the time to air check the low clutches. You do so by applying pressurized air to the passage at the rear pan area of the worm casting in the case. | Now is the time to air check the low clutches. You do so by applying pressurized air to the passage at the rear pan area of the worm casting in the case. | ||
| − | Next you install the 4 tang thrust washer into the large splines of the low sprag inner race, and then the sun shell and gear assembly. | + | [[file:T-350_center_support.jpg]] |
| + | |||
| + | Next you install the 4 tang thrust washer into the large splines of the low sprag inner race (picture above), and then the sun shell and gear assembly. | ||
Before this step, for HD use, you would have wanted to install additional sun gear bushings, 2 on each end, and re-drilled the lube holes. | Before this step, for HD use, you would have wanted to install additional sun gear bushings, 2 on each end, and re-drilled the lube holes. | ||
Shown here. | Shown here. | ||
Your Privacy Choices