The FREE T Bucket plans
m (Reverted edits by 67.142.178.23 (Talk) to last revision by 220.237.109.99) |
|||
| Line 134: | Line 134: | ||
A word of note here - Total Performance makes probably the most long lived and most popular T-bucket, but there is one significant design flaw that they continue to produce. The sleeve that connects the steering box (Corvair) to the steering shaft is extremely weak and can split. This sleeve has two milled slots and is in a shear failure mode with the rolled drive pin. The steering column sleeve should be discarded and a u-joint substituted. You can either mill flats on the supplied shaft and use a DD u-joint, have splines cut on the shaft and uses a splined joint or (though not recommended) use a racing style (TIG/MIG) weld on u-joint. This failure has been corrected by Total Performance in their newer kits; the sleeve has been replaced with a u-joint though it is a weld on. | A word of note here - Total Performance makes probably the most long lived and most popular T-bucket, but there is one significant design flaw that they continue to produce. The sleeve that connects the steering box (Corvair) to the steering shaft is extremely weak and can split. This sleeve has two milled slots and is in a shear failure mode with the rolled drive pin. The steering column sleeve should be discarded and a u-joint substituted. You can either mill flats on the supplied shaft and use a DD u-joint, have splines cut on the shaft and uses a splined joint or (though not recommended) use a racing style (TIG/MIG) weld on u-joint. This failure has been corrected by Total Performance in their newer kits; the sleeve has been replaced with a u-joint though it is a weld on. | ||
| − | + | [[File: | |
==Bracing and mounting the body== | ==Bracing and mounting the body== | ||
| − | For cleanest and simplest body mounting, weld your mounting tabs inside the frame rails at the side part of the cowl, a simple straight 1X2" full cross member at the back edge of the "door" edge bead, and the last about halfway from the "door" bead to the back of the bucket. If you have chosen to not have the framerails sticking inside the cabin with you at the back, weld a tab to the top of the kickup and form it to meet the back wall and install a bolt on each side to stabilize the back wall on these tab mounts. | + | For cleanest and simplest body mounting, weld your mounting tabs inside the frame rails at the side part of the cowl, a simple straight 1X2" full cross member at the back edge of the "door" edge bead, and the last about halfway from the "door" bead to the back of the bucket. If you have chosen to not have the framerails sticking inside the cabin with you at the back, weld a tab to the top of the kickup and form it to meet the back wall and install a bolt on each side to stabilize the back wall on these tab mounts]]. |
Your 3/4-1" marine plywood floor should rest directly on the frame rails on a layer of body to frame webbing or similar material to eliminate any squeaks from movement. Use minimum 3/8 bolts/nuts and large thick flat washers along with lock washers to secure your body down to the frame. After your first 50-100 miles of riding, check all fasteners for tightness. There you are, simple, secure, and solid. | Your 3/4-1" marine plywood floor should rest directly on the frame rails on a layer of body to frame webbing or similar material to eliminate any squeaks from movement. Use minimum 3/8 bolts/nuts and large thick flat washers along with lock washers to secure your body down to the frame. After your first 50-100 miles of riding, check all fasteners for tightness. There you are, simple, secure, and solid. | ||
Your Privacy Choices