Cadillac engine knowledge
(→EFI) |
(→Distributors) |
||
| Line 171: | Line 171: | ||
===Distributors=== | ===Distributors=== | ||
Point-type distributors are similar to the familiar Chevy and use the same internal parts, however the internal shaft and the housing are Cadillac only. Ignition parts for the HEI-style distributors are also the same as the Chevy engine uses, with a few exceptions. First, like the points distributor, the shaft and housing are Cadillac only. Also, the distributor will differ between carbureted and fuel injected engines. The fuel injected distributor has a position sensor under the main body that tells the computer the engine speed and when to trigger the proper injectors. If you're not sure what distributor you have, the carbureted version looks the same as the Chevy, and the fuel injected has a square portion with a round 3 pin plug directly above the clamp area. Finally, the hold-down clamp used will depend on the distributor. They don't interchange, so get the clamp when you get the distributor. Best choice for ignition wires would be a cut-to-fit set, as even the stockers do not fit quite the way they should due to the front-mounted distributor location. | Point-type distributors are similar to the familiar Chevy and use the same internal parts, however the internal shaft and the housing are Cadillac only. Ignition parts for the HEI-style distributors are also the same as the Chevy engine uses, with a few exceptions. First, like the points distributor, the shaft and housing are Cadillac only. Also, the distributor will differ between carbureted and fuel injected engines. The fuel injected distributor has a position sensor under the main body that tells the computer the engine speed and when to trigger the proper injectors. If you're not sure what distributor you have, the carbureted version looks the same as the Chevy, and the fuel injected has a square portion with a round 3 pin plug directly above the clamp area. Finally, the hold-down clamp used will depend on the distributor. They don't interchange, so get the clamp when you get the distributor. Best choice for ignition wires would be a cut-to-fit set, as even the stockers do not fit quite the way they should due to the front-mounted distributor location. | ||
| + | ---------------------------------------------------- | ||
| + | |||
| + | so many people have complained about the cadillac hei distributers having too much advance that i have gone to the chevy distributer and cut it down to fit the cadillac engines. i had so many problems with mine as well from a 76 cadillac 500. it was so hard to time. i suffered greatly until i replaced the unit. | ||
| + | |||
| + | bloodviking | ||
==Cadillac engine parts sources== | ==Cadillac engine parts sources== | ||
Your Privacy Choices