TH350 rebuild tech
(additional photo information) |
|||
| Line 100: | Line 100: | ||
Now is the time to air check the low clutches. You do so by applying pressurized air to the passage at the rear pan area of the worm casting in the case. | Now is the time to air check the low clutches. You do so by applying pressurized air to the passage at the rear pan area of the worm casting in the case. | ||
| − | [[file:T-350_center_support.jpg]] | + | [[file:T-350_anti-rattle_spring.jpg|frame|none|Anti rattle (clunk) spring shown in correct location, use assembly grease to hold in place]] |
| + | |||
| + | |||
| + | |||
| + | [[file:T-350_center_support.jpg|frame|none|Center support, inner race, thrust washer shown]] | ||
Next you install the 4 tang thrust washer into the large splines of the low sprag inner race (picture above), and then the sun shell and gear assembly. | Next you install the 4 tang thrust washer into the large splines of the low sprag inner race (picture above), and then the sun shell and gear assembly. | ||
Your Privacy Choices