How to rebuild an engine
(→Removal) |
(→Removal) |
||
| Line 72: | Line 72: | ||
*Use some type of lift ring on the engine, such as a plate that bolts to where the carburetor was is commonly used. | *Use some type of lift ring on the engine, such as a plate that bolts to where the carburetor was is commonly used. | ||
*Place a jack under the transmission to keep it up right in the vehicle, unless you are removing it Also. | *Place a jack under the transmission to keep it up right in the vehicle, unless you are removing it Also. | ||
| − | *If you plan on removing the Transmission, Don't forget any linkages, Backup lamp switches, Neutral safety switches (some are Transmission mounted) Modulator Valve Vacuum Lines, | + | *If you plan on removing the Transmission, Don't forget any linkages, Backup lamp switches, Neutral safety switches (some are Transmission mounted) Modulator Valve Vacuum Lines,TCC Control wiring. Take a Plastic Baggie, and fit it over the tail-shaft and duct tape it after you remove the Drive-shaft, to keep residual oil IN and Dirt OUT. |
*Jack engine up slightly, and remove the bolts to the motor mounts, and the transmission bell-housing (unless you are removing the transmission also) | *Jack engine up slightly, and remove the bolts to the motor mounts, and the transmission bell-housing (unless you are removing the transmission also) | ||
*Be sure to use padded Fender protectors..A strike from Ring Gear Teeth can do SERIOUS Body and fender damage. | *Be sure to use padded Fender protectors..A strike from Ring Gear Teeth can do SERIOUS Body and fender damage. | ||
Your Privacy Choices