Torque converter lock up control 700R4
m (→Pressure switches) |
(synergy , remove redundancy) |
||
| Line 4: | Line 4: | ||
==Basic wire diagram== | ==Basic wire diagram== | ||
| + | |||
When the brakes are applied the relay switches to pin 87 and the circuit is broken, thus opening the trans feed. | When the brakes are applied the relay switches to pin 87 and the circuit is broken, thus opening the trans feed. | ||
Common type Bosch relay used. | Common type Bosch relay used. | ||
| + | |||
[[Image:Diagram_no_tow.jpg]] | [[Image:Diagram_no_tow.jpg]] | ||
| − | This is a | + | |
| + | This is a simple 12 volt circuit. 12 volts to the solenoid and you need a ground to complete the circuit. If you do not understand basic wiring, get some help from someone with transmission / automotive wire knowledge. | ||
==Pressure switches== | ==Pressure switches== | ||
| + | |||
Notice these are silver in color. This means they are NO = Normally Open. When pressure is applied the switch closes the internal contacts to complete the circuit. Both of these pressure switches are "on -off" design. Pressure turns them "on", no pressure they are "off" | Notice these are silver in color. This means they are NO = Normally Open. When pressure is applied the switch closes the internal contacts to complete the circuit. Both of these pressure switches are "on -off" design. Pressure turns them "on", no pressure they are "off" | ||
| Line 21: | Line 25: | ||
Photo of a pressure switch with two post connectors. This routes the 12 volt power through the switch to a single wire lock up solenoid. | Photo of a pressure switch with two post connectors. This routes the 12 volt power through the switch to a single wire lock up solenoid. | ||
| + | |||
[[image:700_connectors.jpg]] | [[image:700_connectors.jpg]] | ||
| Line 26: | Line 31: | ||
==Lock up solenoids== | ==Lock up solenoids== | ||
| − | + | ||
| − | *1 wire solenoid | + | *1 wire solenoid, early design |
| − | *common 2-wire solenoid | + | *more common 2-wire solenoid late design |
| + | |||
Solenoid on the left has 1 red wire. This is a self-grounding lock up solenoid. The 2-wire solenoid has a red wire and a black wire. Red is for 12 volts, black is for ground. | Solenoid on the left has 1 red wire. This is a self-grounding lock up solenoid. The 2-wire solenoid has a red wire and a black wire. Red is for 12 volts, black is for ground. | ||
| Line 35: | Line 41: | ||
==Valve body location for switch== | ==Valve body location for switch== | ||
| + | |||
Location for pressure switch on valve body for 4th gear lockup only of the torque converter clutch (TCC). This location has pressure when the transmission is in 4th gear. | Location for pressure switch on valve body for 4th gear lockup only of the torque converter clutch (TCC). This location has pressure when the transmission is in 4th gear. | ||
| + | |||
[[Image:700_v-body_switch.jpg]] | [[Image:700_v-body_switch.jpg]] | ||
Your Privacy Choices