TH350 rebuild tech
(Minor clean up; format.) |
(Minor clean up; format.) |
||
| Line 110: | Line 110: | ||
Once the low clutches are installed, you can install the anti-clunk spring (or case-saver). Both are pictured, the case-saver is solid and spreads the load over a larger area. Hold in place with assembly gel or vaseline and then install the low support. | Once the low clutches are installed, you can install the anti-clunk spring (or case-saver). Both are pictured, the case-saver is solid and spreads the load over a larger area. Hold in place with assembly gel or vaseline and then install the low support. | ||
| + | |||
Be sure the low sprag inner race is not brinelled or has any unusual wear. | Be sure the low sprag inner race is not brinelled or has any unusual wear. | ||
| Line 115: | Line 116: | ||
| − | Once it is pushed into place, install the snap ring | + | Once it is pushed into place, install the snap ring with the ends on each side of the spring or case-saver. |
Now is the time to air check the low clutches. You do so by applying pressurized air to the passage at the rear pan area of the worm casting in the case. | Now is the time to air check the low clutches. You do so by applying pressurized air to the passage at the rear pan area of the worm casting in the case. | ||
| − | [[file:T-350_anti-rattle_spring.jpg|frame|none|Anti rattle (clunk) spring shown in correct location | + | [[file:T-350_anti-rattle_spring.jpg|frame|none|Anti rattle (clunk) spring shown in correct location; use assembly grease to hold in place.]] |
[[file:T-350_center_support.jpg|frame|none|Center support, inner race, thrust washer shown.]] | [[file:T-350_center_support.jpg|frame|none|Center support, inner race, thrust washer shown.]] | ||
| Line 134: | Line 135: | ||
Install the input planet next, pictured below with thrust washer installed. | Install the input planet next, pictured below with thrust washer installed. | ||
| − | |||
[[file:T-350_front_planet.jpg|frame|none|Front planet with thrust washer in place.]] | [[file:T-350_front_planet.jpg|frame|none|Front planet with thrust washer in place.]] | ||
Your Privacy Choices