DynoSim combinations

Jump to: navigation, search
m (383 SBC stroker 485 hp/496 ft-lbs torque)
(Add internal links, minor clean up)
Line 115: Line 115:
 
Flat tappet hydraulic cam, stock self aligning (SA) rockers, some head work for better springs.
 
Flat tappet hydraulic cam, stock self aligning (SA) rockers, some head work for better springs.
  
In this build, a tight budget is called for. To that end, use stock self aligning rockers. Lift is under a half inch, so the SA rockers should be OK. Check to see if using a -0.050" lock will be needed to insure the valve tip sticks up far enough above the retainer so that the retainer top surface doesn't get loaded by the side rails of the rail rockers. More on checking clearances, etc. under '''Resources''', below.
+
In this build, a tight budget is called for. To that end, use stock self aligning rockers. Lift is under a half inch, so the SA rockers should be OK. Check to see if using a -0.050" lock will be needed to insure the valve tip sticks up far enough above the retainer so that the retainer top surface doesn't get loaded by the side rails of the rail rockers. More info on checking clearances, etc. under [[DynoSim combinations#Resources|'''Resources''']].
  
 
*Bore the block 0.030", use [http://www.kb-silvolite.com/test/kb_car/performance.php?action=details&P_id=155 '''these'''] or similar 12cc dished pistons w/5.7 rods.
 
*Bore the block 0.030", use [http://www.kb-silvolite.com/test/kb_car/performance.php?action=details&P_id=155 '''these'''] or similar 12cc dished pistons w/5.7 rods.
Line 296: Line 296:
 
*[[Drilling steam holes in smallblock Chevy heads]]
 
*[[Drilling steam holes in smallblock Chevy heads]]
 
*[[Camshaft install tips and tricks]]
 
*[[Camshaft install tips and tricks]]
*[[Computer dyno simulation and engine building software]]
+
*[[Computer dyno simulation and engine building software]]<br>
 +
{{!}}Return to [[DynoSim combinations#350 SBC L31 heads|'''''350 SBC L31 heads''''']]
 +
 
 
[[Category:General hotrodding]]
 
[[Category:General hotrodding]]
 
[[Category:Engine]]
 
[[Category:Engine]]

Revision as of 16:35, 22 December 2012

Personal tools
Namespaces
Variants
Actions
Navigation
Categories
Toolbox