Adjusting solid lifters

Jump to: navigation, search
(Clean up)
m
Line 69: Line 69:
 
In the cases where the cam is unknown and proper measurements impossible, the following may help:
 
In the cases where the cam is unknown and proper measurements impossible, the following may help:
 
*If the engine is running normally, take both cold and hot lash readings. Those reading will obviously be close to the correct lash for that cam and engine.
 
*If the engine is running normally, take both cold and hot lash readings. Those reading will obviously be close to the correct lash for that cam and engine.
*If nothing is known about the cam and the engine isn't running, and the unknown cam has to be used, regardless- set the valves cold to 0.016". 0.016" is used because it's basically at the top of the "tight lash" range, and at the bottom of an old-school cam's wider settings. What you do NOT want to do is set the lash too loose!
+
*If nothing is known about the cam and the engine isn't running, and the unknown cam has to be used, regardless- set the valves cold to 0.016" for an iron head and block engine. 0.016" is used because it's basically at the top of the "tight lash" range, and at the bottom of an old-school cam's wider settings. What you do NOT want to do is set the lash too loose! If you have aluminum heads, go 0.004" to 0.006" tighter on the cold lash.
 
*Most cams have an ID engraved or stamped into them, often on the back end of the cam. The lift and duration @ 0.050" can also be measured if the equipment to degree the cam is available.  
 
*Most cams have an ID engraved or stamped into them, often on the back end of the cam. The lift and duration @ 0.050" can also be measured if the equipment to degree the cam is available.  
  

Revision as of 05:24, 28 December 2012

Personal tools
Namespaces
Variants
Actions
Navigation
Categories
Toolbox