Crankshaft Coalition Wiki
| Line 5: | Line 5: | ||
==Featured articles== | ==Featured articles== | ||
===[[Straightening a rear end housing]]=== | ===[[Straightening a rear end housing]]=== | ||
| + | This article describes how to build an inexpensive table for accurately straightening rear end housings. The table is built from an old gas cylinder cart, an I-beam, and common jackstands, and a bottle jack. Full article: [[Straightening a rear end housing]]. | ||
| + | |||
[[Image:Axle_straightening_table.jpg|thumb|left|A table for straightening rear end housings.]][[Image:Heating_the_axle_tube.jpg|thumb|left|The axle tube is carefully heated at the point of bend.]] | [[Image:Axle_straightening_table.jpg|thumb|left|A table for straightening rear end housings.]][[Image:Heating_the_axle_tube.jpg|thumb|left|The axle tube is carefully heated at the point of bend.]] | ||
| Line 12: | Line 14: | ||
| − | + | ||
Your Privacy Choices