Crankshaft Coalition Wiki
| Line 6: | Line 6: | ||
===[[Straightening a rear end housing]]=== | ===[[Straightening a rear end housing]]=== | ||
This article describes how to build an inexpensive table for accurately straightening rear end housings. The table is built from an old gas cylinder cart, an I-beam, and common jackstands, and a bottle jack. Full article: [[Straightening a rear end housing]]. | This article describes how to build an inexpensive table for accurately straightening rear end housings. The table is built from an old gas cylinder cart, an I-beam, and common jackstands, and a bottle jack. Full article: [[Straightening a rear end housing]]. | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| + | [[Image:Axle_straightening_table.jpg|thumb|left|A gas cylinder cart, converted for straightening rear end housings.]][[Image:Modified_jackstands.jpg|thumb|left|Basic inexpensive jackstands are modified to wrap the I-beam for stability.]][[Image:Straight_bar_in_inserts.jpg|thumb|left|The straight bar, in the inserts.]][[Image:Heating_the_axle_tube.jpg|thumb|left|Heat a band all the way around the tube.]] | ||
Your Privacy Choices