Make a fiberglass fan shroud
| Line 3: | Line 3: | ||
This is a radiator in a 1961 Ford Galaxie that needs a fan shroud. Start by measuring all of the dimensions, taking care to think about how the shroud will attach to the radiator, if there are any obstructions you need to take into consideration, how far away the fan is from the radiator and if there are any angles or off center components. This fan is off center towards the passenger side by about 1/2 inch, sets back about 1 3/8" ,and it swings about 1" above the top of the radiator. It is parallel with the radiator, and there are no hoses or other obstructions to deal with on this particular project. | This is a radiator in a 1961 Ford Galaxie that needs a fan shroud. Start by measuring all of the dimensions, taking care to think about how the shroud will attach to the radiator, if there are any obstructions you need to take into consideration, how far away the fan is from the radiator and if there are any angles or off center components. This fan is off center towards the passenger side by about 1/2 inch, sets back about 1 3/8" ,and it swings about 1" above the top of the radiator. It is parallel with the radiator, and there are no hoses or other obstructions to deal with on this particular project. | ||
| − | [[Image:161_starliner_radiator.JPG|center|600px]] | + | [[Image:161_starliner_radiator.JPG|center|600px|1961 Ford Galaxie radiator.]] |
| + | |||
[[Image:261 Starliner rad rh.JPG|center|600px]] | [[Image:261 Starliner rad rh.JPG|center|600px]] | ||
| − | Using a | + | Using a piece of thin plywood is a good way to start on any part that has a flat mounting surface. The plywood gives a sturdy base upon which to lay out and construct your foam buck. |
[[Image:3start laying out.JPG|center|600px]] | [[Image:3start laying out.JPG|center|600px]] | ||
| + | |||
[[Image:4laid out.JPG|center|600px]] | [[Image:4laid out.JPG|center|600px]] | ||
Your Privacy Choices