Make a fiberglass fan shroud

Jump to: navigation, search

@@ Line 111: / Line 111: @@
 [[Image:Even 29more applying material.JPG|center|600px]]
+Stretch the material over any outside corners, don't try to fold it, it will only spring back. Push the material into inside corners, stretching it as you go. If it gets thin, more material can be added. I usually stretch the material, and wind up with a section of mat that I can reapply to the stretched, thinned out areas.
 [[Image:26applying material.JPG|center|600px]]
+As shown here, hold the material down with one hand while you stretch it over an outside corner with the other. If you pull some material off the edge, you can put it back over the outside of the corner, as it has probably gotten a bit thin there anyway.
-Stretch the material over any outside corners, don't try to fold it, it will only spring back. Push the material into inside corners, stretching it as you go. If it gets thin, more material can be added. I usually stretch the material, and wind up with a section of mat that I can reapply to the stretched, thinned out aresa.
 [[Image:28stretching over corner.JPG|center|600px]]

Revision as of 01:22, 25 June 2007