Make a fiberglass fan shroud
(→Trimming the part) |
(→Laminating the part) |
||
| Line 108: | Line 108: | ||
[[Image:25wetting out buck.JPG|center|600px]] | [[Image:25wetting out buck.JPG|center|600px]] | ||
| − | Pick up the material from the wet out board and apply it to the part. Don't try to push it ito any inside corners or stretch it over any outside corners just yet. | + | Pick up the material from the wet out board and apply it to the part. Don't try to push it ito any inside corners or stretch it over any outside corners just yet. Just get the material stuck to the major flat areas. |
[[Image:Even 29more applying material.JPG|center|600px]] | [[Image:Even 29more applying material.JPG|center|600px]] | ||
Your Privacy Choices