Make a fiberglass fan shroud
(→Laminating the part) |
(→Laminating the part) |
||
| Line 113: | Line 113: | ||
|[[Image:21mat strips.JPG|center|600px|Cut strips of 1 1/2 oz fiberglass mat, and lay them out on a piece of cardboard, ready to be wetted out.] | |[[Image:21mat strips.JPG|center|600px|Cut strips of 1 1/2 oz fiberglass mat, and lay them out on a piece of cardboard, ready to be wetted out.] | ||
|[[Image:22wetting out strips.JPG|center|600px|Brush on only enough resin to cover the mat, and then allow it to soak in.]] | |[[Image:22wetting out strips.JPG|center|600px|Brush on only enough resin to cover the mat, and then allow it to soak in.]] | ||
| − | [[Image:23wetting out some more.JPG|center|600px|Work quickly but carefully, as the resin will gradually dissolve the binder.]] | + | |[[Image:23wetting out some more.JPG|center|600px|Work quickly but carefully, as the resin will gradually dissolve the binder.]] |
|} | |} | ||
Your Privacy Choices