Make a fiberglass fan shroud
(→Laminating the part) |
(→Laminating the part) |
||
| Line 111: | Line 111: | ||
{| | {| | ||
|-valign="top" | |-valign="top" | ||
| − | |[[Image:21mat strips.JPG|center| | + | |[[Image:21mat strips.JPG|center|thumb|Cut strips of 1 1/2 oz fiberglass mat, and lay them out on a piece of cardboard, ready to be wetted out.] |
| − | |[[Image:22wetting out strips.JPG|center| | + | |[[Image:22wetting out strips.JPG|center|thumb|Brush on only enough resin to cover the mat, and then allow it to soak in.]] |
| − | |[[Image:23wetting out some more.JPG|center| | + | |[[Image:23wetting out some more.JPG|center|thumb|Work quickly but carefully, as the resin will gradually dissolve the binder.]] |
|} | |} | ||
Your Privacy Choices