Removing stuck fasteners
(→The weld-on-a-larger-nut method) |
(→Tips for broken-off bolt heads) |
||
| Line 99: | Line 99: | ||
==Tips for broken-off bolt heads== | ==Tips for broken-off bolt heads== | ||
*If enough of the bolt remains, try to grab it with locking pliers or a pipe wrench. | *If enough of the bolt remains, try to grab it with locking pliers or a pipe wrench. | ||
| − | *Try to saw a groove in it, so that a flat-head screwdriver can be used to turn it. Use an impact screwdriver if you have one, it will work | + | *Try to saw a groove in it, so that a flat-head screwdriver can be used to turn it. Use an impact screwdriver if you have one, it will work a lot easier. |
*Take a 12-point socket that is just larger than the shaft of the bolt, and beat it down onto the bolt with a hammer. Turn it out with a ratchet. When finished, put the socket in a vice, and tap out the broken bolt. | *Take a 12-point socket that is just larger than the shaft of the bolt, and beat it down onto the bolt with a hammer. Turn it out with a ratchet. When finished, put the socket in a vice, and tap out the broken bolt. | ||
*If a bolt is broken off below the surface, build it up with a welder until there is enough to which to weld a nut. If this brakes off try it again, this method is the best, the heat and cool cycle of the tig weld will loosen the fastener in the stuck piece. | *If a bolt is broken off below the surface, build it up with a welder until there is enough to which to weld a nut. If this brakes off try it again, this method is the best, the heat and cool cycle of the tig weld will loosen the fastener in the stuck piece. | ||
Your Privacy Choices