John Deere Blitz Black paint

Jump to: navigation, search
(Notes)
(Notes)
Line 19: Line 19:
 
#Wait no longer than 3 hours to apply a second coat. However, one coat with the 8:1:1 paint-thinner-hardener ratio should be adequate.
 
#Wait no longer than 3 hours to apply a second coat. However, one coat with the 8:1:1 paint-thinner-hardener ratio should be adequate.
 
#A gallon will easily cover a small car.
 
#A gallon will easily cover a small car.
 +
 +
==Can you paint over John Deere Blitz Black paint?==
 +
According to John Deere, yes, you can paint over JDBB paint with another coat of primer and/or enamel paint.
 +
 +
However, the wording of the above statement is disputed. While you "can" paint over JDBB paint, it should be done with implement paint only, as a 2K primer, base coat, or urethane single stage will strip. Any enamel (acrylic or alkyd) would likely work. If the paint was activated with a high-enough solids activator '''and''' then sat long enough, it may be possible to shoot a urethane single stage over it, and you '''may''' be able to use a urethane primer if careful. For more information, see: [http://www.hotrodders.com/forum/good-hot-rod-mag-aproved-paint-must-read-128119-3.html#post888190 Hotrodders Bulletin Board forum post].
  
 
==Notes==
 
==Notes==
Line 27: Line 32:
 
*Urethane primer or epoxy primer may also be viable as undercoats for JDBB paint.
 
*Urethane primer or epoxy primer may also be viable as undercoats for JDBB paint.
 
*Some say that JDBB paint is subject to fading and chalking over the years.
 
*Some say that JDBB paint is subject to fading and chalking over the years.
*According to John Deere, yes, you can paint over JDBB paint with another coat of primer and/or enamel paint. '''Disputed''': the wording of this statement is controversial. At least one professional is indicating that while you "can" paint over JDBB paint, it should be done with implement paint only, as a 2K primer, base coat, or urethane single stage will strip. See: [http://www.hotrodders.com/forum/good-hot-rod-mag-aproved-paint-must-read-128119-3.html#post888190 Hotrodders Bulletin Board forum post].
 
 
*Opinions are mixed on using a clearcoat over JDBB. Some say that it can be applied if a flattening agent is used. For a glossy look, wet sanding and buffing are recommended.
 
*Opinions are mixed on using a clearcoat over JDBB. Some say that it can be applied if a flattening agent is used. For a glossy look, wet sanding and buffing are recommended.
  

Revision as of 21:24, 13 November 2007

Personal tools
Namespaces
Variants
Actions
Navigation
Categories
Toolbox