Camshaft install tips and tricks
(→Pre-lube engine oil system) |
(→Engine RPM for break in) |
||
| Line 91: | Line 91: | ||
===Engine RPM for break in=== | ===Engine RPM for break in=== | ||
| − | '''13. Failure to run the motor at 2500 rpm or higher (alternating 500/1000 rpm up and down) to allow the crank and rod big ends to throw oil onto the cam, for a minimum of | + | '''13. Failure to run the motor at 2500 rpm or higher (alternating 500/1000 rpm up and down) to allow the crank and rod big ends to throw oil onto the cam, for a minimum of 30 minutes.''' |
{{Warning}} No idling! The motor should not be run at less than 2500 rpm for a minimum of 20 minutes. If a problem develops, shut the motor down and fix it, then resume break-in. The main sources of camshaft lubrication is oil thrown off of the rods and crankshaft, drain back from the oil rings and oil blowing around inside the crankcase (this is known as "windage"). At idle, the crank isn't spinning fast enough to provide sufficient oil splash to the camshaft/lifters for proper break in protection. | {{Warning}} No idling! The motor should not be run at less than 2500 rpm for a minimum of 20 minutes. If a problem develops, shut the motor down and fix it, then resume break-in. The main sources of camshaft lubrication is oil thrown off of the rods and crankshaft, drain back from the oil rings and oil blowing around inside the crankcase (this is known as "windage"). At idle, the crank isn't spinning fast enough to provide sufficient oil splash to the camshaft/lifters for proper break in protection. | ||
| Line 108: | Line 108: | ||
'''16. Failure to have everything ready for the motor to fire on the first few turns.''' | '''16. Failure to have everything ready for the motor to fire on the first few turns.''' | ||
| − | Fully charged battery, good starter, known-good carburetor with full fuel bowl, source of fuel to the carburetor to allow minimum 20 minutes of uninterrupted running. Ignition timing set. Warning: no grinding on the starter! | + | Fully charged battery, good starter, known-good carburetor with full fuel bowl, source of fuel to the carburetor to allow minimum 20 minutes of uninterrupted running. Ignition timing set. Warning: no grinding on the starter! |
===Pre-lube engine oil system=== | ===Pre-lube engine oil system=== | ||
Your Privacy Choices