|
|
| Line 1: |
Line 1: |
| | {{youcanedit}} | | {{youcanedit}} |
| | Here's how to make a fixture and rack for straightening a rear end housing. | | Here's how to make a fixture and rack for straightening a rear end housing. |
| − |
| |
| − |
| |
| − |
| |
| − |
| |
| − |
| |
| − | ==Measuring==
| |
| − | The housing end insert slides over the bar and indicates how much the end of the housing is bent out of alignment.
| |
| − | [[Image:Housing_end_insert_slid_over_bar.jpg|frame|none|The housing end insert is used to indicate the alignment of the housing.]]
| |
| − |
| |
| − | Hold a ruler on the tube to see where it's bent. In this case, it's bent at the areas that were welded by the previous "builder".
| |
| − | [[Image:Finding_housing_bend.jpg|frame|none|A ruler is used to see where the tube is bent.]]
| |
Your Privacy Choices