Hopping up the 500 Cadillac

Jump to: navigation, search

@@ Line 32: / Line 32: @@
 [[Category:Engine]]
 [[Category:GM]]
+We dyno'd the following 518 cid Cadillac engine. 10.5 to 1 compression, Hydraulic roller cam with 246* at .050 and .620 lift. Single pattern cam on a 112 + 2 LSA. CNC ported MTS aluminum heads and single plain intake. MTS 1.7 to 1 rockers and a Troy Patterson 1100 CFM 4150 carb. MTS ignition system
+Peak HP (620) occurred at 5200 RPM and peak torque (643) occurred at 4700 RPM. At 2600 RPM (the lowest rpm we could get a reading was 543 and by 2900 it was 575 and even at 5400 RPM was still at 590.9. That's a pretty flat torque "curve". The average torque from 2600 rpm to 5300 was 606.6
+Another note is the engine was run on 89 octane fuel. Timing was set at 30* btdc where prior engines run on 93 liked about 6* more.
+As you can see the peak HP at 5200 shows how small a big inch Cadillac with good air flow makes a cam act. This engine would also idle at 600 prm.

Revision as of 15:18, 22 May 2015