Freeing a stuck engine
Crashfarmer (Talk | contribs) (→Unsticking an Engine in a Manual Transmission Vehicle) |
Crashfarmer (Talk | contribs) |
||
| Line 56: | Line 56: | ||
#Don't forget to use horizontal force on the crankshaft. Tap the crankshaft at both ends with your dead blow hammer and oak block. Loosen off the rod bearings and tap with a bronze hammer to break the shell bearings loose. | #Don't forget to use horizontal force on the crankshaft. Tap the crankshaft at both ends with your dead blow hammer and oak block. Loosen off the rod bearings and tap with a bronze hammer to break the shell bearings loose. | ||
#After you've done all of the above, let 'er soak and then start over again. She'll loosen! | #After you've done all of the above, let 'er soak and then start over again. She'll loosen! | ||
| − | + | ==Unsticking an Engine in a Manual Transmission Vehicle== | |
I have had success in unsticking an engine in vehicles on a number of occasions buy using the pre-soaking methods mentioned above for a long period. | I have had success in unsticking an engine in vehicles on a number of occasions buy using the pre-soaking methods mentioned above for a long period. | ||
Once the engine has soaked I jack up one drive wheel, put the transmission in high gear and work the wheel back and forth. | Once the engine has soaked I jack up one drive wheel, put the transmission in high gear and work the wheel back and forth. | ||
This can take quite a while and it is quite tiring but you will notice the wheel will start to move a little farther if the process is going to succeed. | This can take quite a while and it is quite tiring but you will notice the wheel will start to move a little farther if the process is going to succeed. | ||
Once I can get the drive wheel to rotate several revolutions I like to pull the vehicle in high gear several miles with all the plugs removed. This is probably not necessary but I like to think that it gets everything lubricated up good. | Once I can get the drive wheel to rotate several revolutions I like to pull the vehicle in high gear several miles with all the plugs removed. This is probably not necessary but I like to think that it gets everything lubricated up good. | ||
Your Privacy Choices