Media blasting

Jump to: navigation, search
(Resource dump)
(Sandblasting sheet metal)
Line 61: Line 61:
 
Cautions about this.
 
Cautions about this.
  
* Prolonged sand blasting of thin sheet metal causes frictional heat that may cause the metal to ding, warp, or pit. Be aware of this if you especially are going to be doing a long, flat, unsupported body panel. The best way to avoid this on long spans is to spread out the blast from the gun so that not one area receives the brunt of the abrasive blast for a long period of time. It also gives it time to cool.
+
* Prolonged sand blasting of thin sheet metal causes frictional heat (''frictional heat, or peening?'') that may cause the metal to ding, warp, or pit. Be aware of this if you especially are going to be doing a long, flat, unsupported body panel. The best way to avoid this on long spans is to spread out the blast from the gun so that not one area receives the brunt of the abrasive blast for a long period of time. It also gives it time to cool.
  
 
==Recycling media==
 
==Recycling media==

Revision as of 18:47, 29 July 2009

Personal tools
Namespaces
Variants
Actions
Navigation
Categories
Toolbox