TH350 rebuild tech
m (→1- 2 Accumulator: correct format stuff) |
m (→Low-reverse piston install) |
||
| Line 50: | Line 50: | ||
Install new seals on the low piston, these are square cut seals, not lip seals. | Install new seals on the low piston, these are square cut seals, not lip seals. | ||
| − | [[File:TH350lowpiston.jpg]] | + | [[File:TH350lowpiston.jpg|frame|none| Piston has 3 seals on it. That creates 2 separate sections]] |
Then push it into the rear of the case evenly by hand, aligning it properly so it will seat (there is a "tang"). Look at the park pawl notch to help index it. | Then push it into the rear of the case evenly by hand, aligning it properly so it will seat (there is a "tang"). Look at the park pawl notch to help index it. | ||
| − | [[file:TH350caselowpiston.jpg]] | + | [[file:TH350caselowpiston.jpg|frame|none|Low-reverse piston installed into case]] |
Then install the return spring and retainer using the tool pictured. | Then install the return spring and retainer using the tool pictured. | ||
| − | [[file:TH350lowspringtool.jpg]] | + | [[file:TH350lowspringtool.jpg|frame|none| Tool used to compress the springs & retainer to install the retaining snap ring ]] |
| − | [[file:TH350caselowtool.jpg]] | + | [[file:TH350caselowtool.jpg|frame|none|Spring compression tool installed into case]] |
=Out put shaft install= | =Out put shaft install= | ||
Your Privacy Choices