Torque converter lock up control 700R4
m (Clean up.) |
|||
| Line 4: | Line 4: | ||
==Basic wire diagram== | ==Basic wire diagram== | ||
| − | |||
| − | |||
When the brakes are applied the relay switches to pin 87 and the circuit is broken, thus opening the trans feed. | When the brakes are applied the relay switches to pin 87 and the circuit is broken, thus opening the trans feed. | ||
| − | + | Common type Bosch relay used. | |
| − | Common type | + | |
| − | + | ||
| − | + | ||
[[Image:Diagram_no_tow.jpg]] | [[Image:Diagram_no_tow.jpg]] | ||
| − | This is a common 12 volt circuit. | + | This is a common 12 volt circuit. 12 volts to the solenoid and you need a ground to complete the circuit. If you do not understand basic wiring, get some help from someone with that knowledge. |
| − | + | ||
| − | + | ||
==Pressure switches== | ==Pressure switches== | ||
| + | Notice these are silver in color. This means they are NO = Normally Open. When pressure is applied the switch closes the internal contacts to complete the circuit. Both of these pressure switches are "on -off" design. Pressure turns them "on", no pressure they are "off" | ||
| − | + | The pressure switch with 1 pole on it is self-grounding. This means the wire you hook to it is going to be grounded when pressure is applied to the switch. | |
| − | + | ||
| − | The pressure switch with 1 pole on it is self grounding. This means the wire you hook to it is to be grounded when pressure is applied to the switch. | + | |
[[Image:700_pressure_switches.jpg]] | [[Image:700_pressure_switches.jpg]] | ||
| − | Photo of a pressure switch with two post connectors. This routes the 12 volt | + | Photo of a pressure switch with two post connectors. This routes the 12 volt power through the switch to a single wire lock up solenoid. |
[[image:700_connectors.jpg]] | [[image:700_connectors.jpg]] | ||
| − | ==Lock up | + | ==Lock up solenoids== |
| − | Solenoid designs | + | ===Solenoid designs=== |
| + | *1 wire solenoid | ||
| + | *common 2-wire solenoid | ||
| + | Solenoid on the left has 1 red wire. This is a self-grounding lock up solenoid. The 2-wire solenoid has a red wire and a black wire. Red is for 12 volts, black is for ground. | ||
[[image:700_solenoid_wires.jpg]] | [[image:700_solenoid_wires.jpg]] | ||
| + | |||
==Valve body location for switch== | ==Valve body location for switch== | ||
| − | + | Location for pressure switch on valve body for 4th gear lockup only of the torque converter clutch (TCC). This location has pressure when the transmission is in 4th gear. | |
| − | + | ||
| − | Location for pressure switch on valve body for 4th gear lockup only of the converter clutch. | + | |
[[Image:700_v-body_switch.jpg]] | [[Image:700_v-body_switch.jpg]] | ||
Your Privacy Choices