TH350 rebuild tech
| Line 67: | Line 67: | ||
Install new seals on the low piston, these are square cut seals, not lip seals. | Install new seals on the low piston, these are square cut seals, not lip seals. | ||
| − | [[File:T-350_low_piston.jpg| | + | |
| + | [[File:T-350_low_piston.jpg|thumb|300px|left|T-350 Low-reverse piston has 3 seals on it. That creates 2 separate sections.]] <br style="clear:both"/> | ||
| + | |||
Then push it into the rear of the case evenly by hand, aligning it properly so it will seat (there is a "tang"). Look at the park pawl notch to help index it. | Then push it into the rear of the case evenly by hand, aligning it properly so it will seat (there is a "tang"). Look at the park pawl notch to help index it. | ||
| − | |||
| + | [[File:T-350caselowpiston.jpg|thumb|300px|left|T-350 Low-reverse piston installed into case.]] <br style="clear:both"/> | ||
Then install the return spring and retainer using the tool pictured. | Then install the return spring and retainer using the tool pictured. | ||
| − | [[ | + | |
| + | [[File:T-350_low_pist_springtool.jpg|thumb|300px|left|Tool used to compress the springs & retainer to install the retaining snap ring.]] <br style="clear:both"/> | ||
==Output shaft install== | ==Output shaft install== | ||
Your Privacy Choices