TH350 rebuild tech
(→Output shaft install) |
(→Dual Feed direct drum) |
||
| Line 265: | Line 265: | ||
Even firmer shifts can be accomplished with check ball removal and modifications to the accumulators. It is recommend to NOT modify the 1-2 accumulator. Retain the cushion spring and do not block the circuit. The 2-3 accumulator can be blocked by several methods. | Even firmer shifts can be accomplished with check ball removal and modifications to the accumulators. It is recommend to NOT modify the 1-2 accumulator. Retain the cushion spring and do not block the circuit. The 2-3 accumulator can be blocked by several methods. | ||
| − | Removing the 2-3 accumulator spring and using a spacer (nut, washers, cut down section of tubing) between the piston and the E-clip is the "shade tree | + | Removing the 2-3 accumulator spring and using a spacer (nut, washers, cut down section of tubing) between the piston and the E-clip is the "shade tree" method. You can also block the feed in the valve body to the 2-3 accumulator. |
Installing the direct piston will require some patience, a lip seal installed or 0.010" feeler gauge, and a trick to use is a section of plastic cut from a 3 liter soda bottle to use as an outside installer tool. Set it in the drum, and it will force the lip seal into the drum without using a tool around the entire circumference. You may however need to work the exposed part of the seal into the drum with the feeler gauge or seal tool. | Installing the direct piston will require some patience, a lip seal installed or 0.010" feeler gauge, and a trick to use is a section of plastic cut from a 3 liter soda bottle to use as an outside installer tool. Set it in the drum, and it will force the lip seal into the drum without using a tool around the entire circumference. You may however need to work the exposed part of the seal into the drum with the feeler gauge or seal tool. | ||
Your Privacy Choices