Rebuild an alternator
(→Installation and inspection) |
m (Reverted edits by 121.91.200.89 (talk) to last revision by Cobalt327) |
||
| Line 22: | Line 22: | ||
*With a fine emery or crocus cloth, burnish the brush pickups or (slip rings) on the rotor assembly until smooth and shiny. Emery dust is conductive so clean up your work when done. | *With a fine emery or crocus cloth, burnish the brush pickups or (slip rings) on the rotor assembly until smooth and shiny. Emery dust is conductive so clean up your work when done. | ||
| − | + | === Installation and inspection === | |
* Install your new bearing, but before you do, get a SMALL sharp punch and carefully put a dimple in the race each 1/3 rd the way around. One may use a dab (small dab) of epoxy to accomplish locking the bearing race. This will prevent the race from spinning in the case. It will be a tiny bit harder to put the cases back together, you might have to tap the halves with a rubber mallet. | * Install your new bearing, but before you do, get a SMALL sharp punch and carefully put a dimple in the race each 1/3 rd the way around. One may use a dab (small dab) of epoxy to accomplish locking the bearing race. This will prevent the race from spinning in the case. It will be a tiny bit harder to put the cases back together, you might have to tap the halves with a rubber mallet. | ||
* Install the bushing (if applicable). Lubricate the bushing as required. | * Install the bushing (if applicable). Lubricate the bushing as required. | ||
Your Privacy Choices